Advertisement
Figure 16
1. Strap buckle
2. Retaining nut
3.
From 1 side of the groomer reel, slide a brush
into each groove around the full length of the
groomer reel
(Figure
Figure 17
1. Strap
2. Brush
4.
Verify that the brushes are seated in the groomer
blade slots
(Figure 16
3. Strap
4. Brush
17).
3. Toward rear of machine
and
Figure
18).
1. Brush
5.
Loosely wrap the straps, as shown in
16, around the groomer reel shaft and brushes,
inserting the straps in the grooves in the brushes
Figure
18.
Position the brushes so that the straps are
between the following blades: 2 and 3; 12 and
13; 23 and 24 or 24 and 25; 35 and 36, and 45
and 46.
Important:
g032403
the groomer blade and brush assembly in the
primary rotating direction.
the straps installed for forward rotation.
Note:
If the broomer brushes are not
seated properly in the blade slots, loosen the
groomer-blade retaining nuts on each end of the
groomer shaft, position the broomer brushes
properly in the blade slots, and tighten the
groomer-blade retaining nuts
6.
Tighten the groomer blade retaining nuts; torque
them to 45.2 N∙m (400 in-lb).
7.
While pushing a screwdriver against the strap
buckle, grasp the strap with a locking pliers and
pull the straps tight until they lock into the brush
grooves
(Figure
8.
Trim the strap so that it is 6 mm (1/4 inch) from
the buckle and fold the excess strap over the
buckle.
g232518
10
Figure 18
2. Blade
You must wrap the straps around
Figure 17
(Figure
16).
g032402
Figure
shows
16).
Advertisement
