Install A Hot-Swap Drive - Lenovo ThinkSystem SR650 Series Setup Manual

Figure 114. Top cover installation
Note: Before you slide the top cover forward, ensure that all the tabs on the top cover engage the chassis
correctly. If the tabs do not engage the chassis correctly, it will be very difficult to remove the top cover later.
Step 1. Ensure that the cover latch is in the open position. Lower the top cover onto the chassis until both
sides of the top cover engage the guides on both sides of the chassis.
Step 2. Pivot the cover latch and slide the top cover to the front of the chassis at the same time until the top
cover snaps into position. Ensure that the cover latch is closed.
Step 3. Use a screwdriver to turn the cover lock to the locked position.

Install a hot-swap drive

Install a hot-swap drive by sliding it into the drive bay and closing the drive bay handle.
"Read the
installation
Guidelines" on
page 126
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive and place it on a static-protective surface.
190
ThinkSystem SR650 Setup Guide
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 127