Electrical Safety; Package Contents; Mains Plug Replacement (U.k. & Ireland Only) - DeWalt DC013 Original Instructions Manual

EN GLI SH
Use only with D WALT battery packs;
E
others may burst, causing personal injury
and damage.
Do not expose to water.
Have defective cords replaced
immediately.
Charge only between 4 °C and 40 °C.
Discard the battery pack with due care for
the environment.
Do not incinerate the battery pack
NiMH, NiCd+ and Li-Ion.
Charges NiMH and NiCd battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.

Package Contents

The package contains:
1 Charger/radio
1 Instruction manual
1 Exploded drawing
• Check for damage to the charger/radio, parts
or accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fi g. 1, 2)
WARNING: Never modify the
charger/radio or any part of it.
Damage or personal injury could result.
a. Power/Volume control
b. Tuning dial
c. Arrow buttons
d. Mode button
e. Clock button
f. Memory buttons
g. LCD display
h. Battery compartment latch
26
i. Charging receptable
j. Charging light
k. Auxiliary port
l. USB power output port
m. Coin cell battery door
n. Coin cell battery
o. Outlets (DC013-GB, DC013-QW, DC013-BD)

Electrical Safety

Always check that the battery pack voltage
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
WARNING: Risk of electric shock. Use
in dry locations only.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm ; the maximum length is 30 m.
2
When using a cable reel, always unwind the cable
completely.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: Do not place the charger/
radio in locations where it may be
exposed to dripping or splashing.