Table of Contents
Advertisement
A.
Allow the control levers to return to neutral
and loosen the 2 jam nuts on the hex
adjustment linkage
Note:
One jam nut is a right-hand thread
and the other is left-hand.
1. Hex adjustment linkage jam nut
B.
Turn the hex adjustment linkage until there
is 3 to 6 mm (1/8 to 1/4 inch) gap between
the control lever and the front reference bar.
C.
Tighten the jam nuts
3.
Allow the control levers to return to neutral.
Turn the left hex adjustment link until the motion
control levers are approximately even with each
other.
4.
Repeat steps
2
and
control linkage.
Adjusting the Motion
Control Tracking
If the machine travels or pulls to one side when the
motion control levers are in the full forward position,
adjust the tracking.
1.
Push both control levers forward the same
distance.
2.
Check if the machine pulls to one side; If it does,
stop the machine and set the parking brake.
3.
Loosen the lock nuts on the right motion control
linkage (as viewed from the rear of the machine.
Push the right control lever forward and rotate
the adjustment rod until there is 1/8 to 1/4 inch
(3 to 6 mm) gap between the right control lever
and the front reference bar.
4.
Place the front reference/speed control bar in the
maximum forward position; refer to
Front Reference/Speed Control Bar (page
(Figure
46).
Figure 46
(Figure
46).
3
for the other motion
Adjusting the
5.
Rotate the adjustment rod on the left side of the
machine
1. Adjustment rod
6.
Looking down towards the adjustment rod —
g231567
rotate it counterclockwise, in 1/4 turn increments,
to increase speed or clockwise to decrease
speed.
7.
Drive the machine and check the full forward
tracking.
8.
Repeat steps
is obtained.
Check Transmission Mount
Bolt Torque
Service Interval: After the first 5 hours
Yearly thereafter
Torque the 4 transmission bolts to 56-69 N-m (41-51
ft-lb); refer to
Note:
Do Not use anti-seize compound on the wheel
hub.
1. Transmission bolts
16).
40
(Figure
47).
Figure 47
5
through
7
until desired tracking
Figure
48.
Figure 48
g233418
g233601
Advertisement
Table of Contents
