Sensors; Diagnostics - Toro EVOLUTION Series User Manual

Sensors

The Sensors function allows you to assign a rain sensor to each of the schedules. Schedules with a rain sensor assigned will not water when
the sensor is activated.
Step 1
– While in the ADVANCED menu, use the Up
Step 2
– Use the Up
Step 3
– Use the Left
Step 4
– Use the Up
rain sensor is activated, EVOLUTION
the sensor for that schedule.
SENSORS
A
RAIN
Use the Right
RAIN SENSOR
RAIN DELAY
CURRENT STATE IS DRY
Step 5
– Select Rain Delay. Press SELECT
Step 6
– Use the Up
sensor is detected to be dry.
Step 7
– Press the BACK

Diagnostics

TM
The EVOLUTION controller provides a diagnostic function to check whether the system's zones are properly functioning. When
activated, the controller will test each available zone. EVOLUTION
been tested, OK for zones working within the current draw range, OVERCRNT for zones drawing above the recommended current draw,
or SHORT for zones that have a grounded circuitry.
DIAGNOSTICS
ZONE TEST
20
or Down arrows to select the sensor you want to set.
or Right arrows to select the schedule.
or Down arrows to place a check mark under the desired schedules to assign the rain sensor. When the
TM
will prevent schedules from operating. Replace the check mark with a dash to disable
B Ca
arrows to select to access the sensor setup screen.
OFF
or Right
or Down arrows to set a delay of 1-14 days or OFF. The rain delay is the waiting period after the rain
arrow to return to the previous menu or
ZONE CURRENT TEST
MASTER VALVE OK
ZONE 1 OVERCRNT
ZONE 2 SHORT
ZONE 3 ––
or Down arrows to select the SENSORS. Press SELECT
arrows to navigate to the parameter.
HOME to return to the main screen.
TM
will display dashes (--) for zones that are being tested and have not
.