Figure 3-9 Enter Ip Address; Figure 3-10 Typical Display With Entered Values; Figure 3-11 Switching The Protocol To Modbus Tcp; Figure 3-12 Restart Prompt - Siemens SENTRON PAC3200 Manual

F3
F2
values is followed again by the lowest.
Figure 3-9
F4
Change to the next line SUBNET with F3
Repeat the procedure described for the settings SUBNET and GATEWAY.
Figure 3-10
Switching from the SEAbus TCP protocol to MODBUS TCP
Use F3
Press F4
Switch the protocol from "SEAbus TCP" to "MODBUS TCP" with F2
Figure 3-11
Confirm your selection with F4
F1
Figure 3-12
F4
SENTRON PAC3200
Manual, 02/2008, A5E01168664B-04
runs through the digits of the value from left to right.
increments the value at the selected digit. The highest value of the available set of
Enter IP address
saves the set IP ADDRESS and returns to display mode.
Typical display with entered values
to change to the "PROTOCOL" entry
.
Switching the protocol to MODBUS TCP
terminates the input and a message window prompts you to restart.
Restart prompt
carries out a restart - your settings become effective.
, and press F4
.
Description
3.9 Ethernet port
.
39