6.2.4
CONTROL
Description
The CONTROL method is run through when the current control has changed for an opened
screen, i.e. typically at a 1:n switchover.
Programming
Syntax:
Description:
Parameters:
See also
Variable S_CONTROL (Page 117)
6.2.5
FOCUS
Description
The FOCUS method is executed if the focus (cursor) is positioned on another field in the dialog.
The FOCUS method must not be initiated as a result of a navigation event. The cursor position
may only be changed in softkey PRESS methods, CHANGE methods, etc. The response of
cursor movements is predefined.
Note
Within the FOCUS method, it is not possible to select a different variable, nor can a new dialog
be loaded.
Programming
Syntax:
Description:
Parameters:
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 12/2017, 6FC5397-1DP40-6BA1
CONTROL
<instructions>
END_CONTROL
Control switchover
- None -
FOCUS
...
END_FOCUS
Positions the cursor
- None -
Programming commands
6.2 Methods
129