Table of Contents
Advertisement
Note
If you are installing a hard disk drive in a system that
previously had only a floppy drive there will be two
sets of holes available in the bay. Install the hard
drive in the position closer to the floppy drive.
4. Carefully tighten the screws.
5. Turn the bay over.
Reassembling the system
1. Replace the 3.5" drive bay in the system unit. Make
sure that the cutouts in the bay align with the lugs in
the base of the system unit.
2. Carefully slide the 3.5" drive bay forwards. The bay
is in position when the floppy drive operating button
protrudes through the front bezel and the two screw
holes in the bay line up with those in the base of the
system unit.
3. Replace the two securing screws.
4. Connect the 3.5" hard disk(s) to their signal and
power cables.
5. Reconnect the 3.5" floppy drive cable.
Warning
If the 3.5" floppy drive cable has been disconnected
from the system board make sure that you
reconnect it to the correct connector. Check the
label on the inside of the system unit cover.
6. Replace the 5.25" bay in the system unit.
7. Slide the bay forwards until the two holes in the bay
line up with those in the hard drive assembly and the
system unit brace.
8. Replace the two screws which secure the 5.25"
drive bay.
9. If there is a drive in the bay reconnect its power and
signal cables.
10. Replace the system unit cover.
52
Advertisement
Table of Contents
