Mitsubishi Electric apricot XEN-LS II Using Setup And Installing Add-Ons page 33

4. Pushing gently on the top corners rotate the SIMM
towards the horizontal until it clips into place. Do not
use excessive force.
If the SIMM will not rotate easily remove it and start
again.
5. If the SIMM is properly located the SIMM should
remain in position held by the securing clips, and
with a small plastic lug through the holes on either
side of the SIMM.
If you want to install a second SIMM repeat the process
above. Once you have completed installation you can
replace the 5.25" drive bay and reassemble the system.
1. Replace the 5.25" bay in the system unit.
2. Slide the bay forwards until the two holes in the bay
line up with those in the hard drive assembly and the
system unit brace.
3. Replace the two screws which secure the 5.25"
drive bay.
4. If there is a drive in the bay reconnect its power and
signal cables.
5. Replace the system unit cover.
The next time you power the system up the SETUP utility
will be invoked automatically.
31