Changing The Size Of The Ice Cubes; Setting The Water Volume - Miele KFN 37452 iDE Operating And Installation Instructions

Changing the size of the ice
cubes
The size of the ice cubes depends on
the quantity of water being taken in.
You are able to set this quantity
according to your requirements. To
make larger ice cubes, increase the
amount of water being taken in by the
ice-cube maker. The amount of water is
set to medium (E 3) at the factory.

Setting the water volume

The setting can only be selected if the
ice cube maker is switched on.
 Touch the settings sensor.
All symbols available for selection will
appear in the display and the  symbol
flashes.
 Touch the sensors for setting the
temperature (or ) repeatedly until
the the ice cube maker symbol 
flashes in the display.
 Touch the OK sensor to confirm your
selection.
 By touching the  and  sensor you
can now alter the water volume:
0: the ice cube maker is switched off
1: the ice cube maker is switched on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker
 Touch the OK sensor to confirm your
selection.
Making ice cubes
 By touching the  or  sensor, you
can now set the water volume you
require (E1 to E8):
E1: low water volume
E8: high water volume
 Touch the OK sensor to confirm your
selection.
The selected setting is applied.
 Touch the settings sensor to leave
settings mode, or
 Close the appliance door.
Otherwise the appliance will switch to
normal operation after approximately
one minute.
59