Miele KFN 37452 iDE Operating And Installation Instructions page 64

Cleaning and care
The "Rinse the ice cube maker"
setting can only be selected when the
ice cube maker is switched on and the
water container has been filled.
 Touch the settings sensor.
All symbols available for selection
appear in the display and the  symbol
flashes.
 Touch the sensors for setting the
temperature ( and ) repeatedly
until the ice cube maker symbol 
flashes in the display.
 Touch the OK sensor to confirm the
selection.
 By touching the  and  sensors,
you can now select the setting you
want:
0: the ice cube maker is switched off
1: the ice cube maker is switched on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker
 Touch the OK sensor to confirm the
selection.
The selected setting is applied. The ice
cube maker symbol  in the display
and the indicator light on the ice cube
maker will flash while the ice cube
maker is being rinsed.
You will hear the ice cube tray turn so
that it is at an angle.
64
 Wait until the ice cube tray has
completed this rotation before
continuing.
The ice cube maker will then switch off.
The symbol for the ice cube maker 
will disappear from the display.
 Carefully remove the ice cube drawer,
which will be full of water. Empty and
clean it.
The ice cube tray cannot be removed
and must be cleaned in situ.
 Dry the ice cube tray  with a cloth.
When the ice cube maker is switched
back on again, the ice cube tray will
rotate back into the original position.