Table of Contents
Advertisement
2.3
Technical features and ambient conditions
2.3.1
Directives and standards
Standards that are complied with
SIMOTICS S, SIMOTICS M, SIMOTICS L, SIMOTICS T, SIMOTICS A motors –
subsequently called the "SIMOTICS motor series " – comply with the following standards:
● EN 60034-1 – Rotating electrical machines – Dimensioning and operating behavior
● EN 60204-1 – Safety of machinery – Electrical equipment of machines; general
requirements
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
IEC / EN 60034:
Feature
Degree of protection
Cooling
Type of construction
Connection designations
Noise levels
Temperature monitoring
Vibration severity levels
Standard component, e.g. cannot be applied to built-in motors
1)
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the area of validity covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.
European EMC Directive
SIMOTICS motors do not fall within the area of validity covered by the EMC Directive. The
products are not considered as devices in the sense of the directive.
1FW68 radial segment motors
Configuration Manual, 04/2017, 6SN1197-0AE02-0BP1
1)
1)
1)
Description of the motors
2.3 Technical features and ambient conditions
Standard
IEC / EN 60034-5
IEC / EN 60034-6
IEC / EN 60034-7
IEC / EN 60034-8
IEC / EN 60034-9
IEC / EN 60034-11
IEC / EN 60034-14
29
Advertisement
Table of Contents
