Dhcp Options - Siemens SIMATIC NET SCALANCE W780 Series Configuration Manual
Industrial wireless lan scalance w780/w740 to ieee 802.11n web based management
Hide thumbs
Also See for SIMATIC NET SCALANCE W780 Series:
- Configuration manual (317 pages) ,
- Reference manual (84 pages)
Table of Contents
Advertisement
● Enable
Specify whether or not this IPv4 address band will be used.
Note
If you enable the IPv4 address band. the settings in this and the other DHCP tabs ate
grayed out and can no longer be edited.
● Subnet
Enter the network address range that will be assigned to the devices. Use the CIDR
notation.
● Lower IP address
Enter the IPv4 address that specifies the start of the dynamic IPv4 address band. The
IPv4 address must be within the network address range you configured for "Subnet".
● Upper IP address
Enter the IPv4 address that specifies the end of the dynamic IPv4 address band. The
IPv4 address must be within the network address range you configured for "Subnet".
● Lease Time (sec)
Specify for how many seconds the assigned IPv4 address remains valid. When half the
lease time has elapsed. the DHCP client can extend the period of the assigned IPv4
address. When the entire time has elapsed, the DHCP client needs to request a new IPv4
address.
6.5.11.3
DHCP Options
On this page you specify which DHCP options the DHCP server supports. The various
DHCP options are defined in RFC 2132.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
Configuring with Web Based Management
6.5 "System" menu
221
Hide quick links:
Advertisement
Table of Contents
