Find Breaks In The Loop Wire - Husqvarna Automower 310 Operator's Manual

Symptoms Cause
Both the mowing The battery is spent.
and charging times
are shorter than
usual.
The product is The product has an inbuilt standby peri-
parked for hours in od according to the Standby time table.
the charging sta- Refer to
35 .
tion.
The hatch has been closed without the
START button first being pressed.
The product often Spiral cutting is a natural part of the
moves in circles or movement pattern.
spirals.
Uneven mowing The product works too few hours per
results. day.
The
relation to the layout of the work area.
The shape of the work area requires
the use of
find its way to all remote areas.
The work area is too large.
Blunt blades.
Long grass in relation to the set cutting
height.
Accumulation of grass by the blade
disc or around the motor shaft.

6.6 Find breaks in the loop wire

Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such
as when gardening with a shovel. In countries
with ground frost, also sharp stones that move in
the ground can damage the wire. Breaks can
also occur due to the wire being stretched
excessively during installation.
1220 - 001 -
Timer and Standby on page
How often? setting is incorrect in
Area 1-3 for the product to
Action
Replace the battery. Refer to
on page 39 .
No action.
Open the hatch, press the START but-
ton and then close the hatch.
Adjust how often the Spiral Cutting
function shall be performed. The func-
tion can be disabled if necessary. Refer
To set the level of Spiral Cutting on
to
page 30 .
Increase the mowing time. Refer to
set the timer on page 24 .
Check that the correct
ue is selected.
Area 1-3 to steer the product to a
Use
remote area. Refer to
coverage function on page 26 .
Try to limit the work area or extend the
work time. Refer to
page 24 .
Replace all the blades. Refer to
place the blades on page 39 .
Increase the cutting height and then
successively lower it.
Check that the blade disc rotates freely
and easily. If not, screw off the blade
disc and remove grass and foreign ob-
Clean the product on
jects. Refer to
page 38 .
Mowing the grass too low right after the
installation can damage wire insulation. Damage
to the insulation may not cause disruptions until
several weeks or months later. To avoid this,
always select the maximum cutting height the
first weeks after installation and then lower the
height one step at a time every second week until
the desired cutting height has been reached.
A defective splicing of the loop wire can also lead
to disruptions several weeks after the splice was
Battery
To
How often? val-
To set the Lawn
To set the timer on
To re-
Troubleshooting - 49