After The Installation Of The Product; To Do The Product Settings - Husqvarna Automower 310 Operator's Manual

Note: Make sure that you can see the ends
of the boundary wire or the guide wire
through the transparent area of the coupler.
5. Push the button on the coupler with an
adjustable pliers.
6. Put the boundary wire or the guide wire into
position with stakes.

3.8 After the installation of the product

3.8.1 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on
the charging station has a green light.
2. If the indicator LED lamp does not have a
green light, do a check of the installation.
Indicator lamp in the charging
Refer to
station on page 47 and To install the
charging station on page 21 .
3.8.2 To do the basic settings
Before you start the product for the first time, you
must do the basic settings and calibrate the
product.
1. Push the STOP button.
2. Set the Main switch to 1.
3. Push the arrow buttons and the OK button.
language, country, date, time and set
Select
a PIN code.
Note: It is not possible to use 0000 as PIN
code.
4. Put the product in the charging station.
5. Push the START button and close the hatch.
1220 - 001 -
Note: Some models require a factory PIN code
before the selection of personal PIN code.
Note: Use the MEMO page at the beginning of
the manual to make a note of the PIN code.
Introduction on page 3 .
The product then moves away from the charging
station and stops, while it calibrates some of the
product settings.

3.9 To do the product settings

The product has factory settings but the settings
can be adapted to each work area.
3.9.1 To get access to the menu
1. Push the STOP button.
2. Enter the PIN code on the keypad.
3. Push the MENU button.
3.9.2 To do the timer settings
3.9.2.1 To calculate the timer setting
1. Calculate the dimension of your lawn in m
2
yd .
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to
table below.
3. The result is equal to the number of hours
that the product must operate each day.
Note: The operation capacity is approximate and
timer settings can be adjusted.
Model Approximate operation ca-
pacity, m
®
Automower 310 56 / 0.01
®
Automower 315 68 / 0.02
®
Automower 315X 73 / 0.02
Example: A lawn of 500 m
®
Automower 310.
2
/
2 2
/h / yd /h
2 2
/ 600 yd , cut with a
Installation - 23