Husqvarna Automower 310 Operator's Manual page 32

To enable the GeoFence function
GeoFence is a GPS-based theft protection that
makes a virtual fence for the product. You will get
a message if the product is moved on the other
side of the GeoFence.
1. Put the product in the center of the work
area.
To get access to the menu
2. Do steps 1–3 in
on page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
GeoFence > Activate GeoFence .
4. Push the OK button.
Activate GeoFence and push the OK
5. Select
button.
To set a new center point for the Geofence
function
1. Put the product in the center of the work
area.
To get access to the menu
2. Do steps 1–3 in
on page 23 .
3. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
GeoFence > New center point .
4. Push the OK button.
To set the GeoFence level of sensitivity
The higher level of GeoFence sensitivity, the
easier the alarm starts.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
GeoFence .
3. Use the arrow buttons to select level of
GeoFence sensitivity.
4. Push the BACK button.
To use the SMS function
The SMS function sends you an SMS when the
product is moved out of the GeoFence.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
32 - Installation
Accessories > Automower Connect >
Communication > Use SMS .
3. Push the OK button.
4. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
Communication > SMS phone numbers .
5. Push the number buttons to enter the
telephone number with country code. For
example (+)46701234567.
6. Push the BACK button.
Note: There is a maximum of 10 SMS each
month from the product.
Network
APN settings
The product must specify APN settings to be able
to use and send data via the mobile net. Settings
for Husqvarna SIM is default.
3.9.11.5 Headlights
To set the schedule for the headlights
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Headlights > Schedule .
Always ON, Evening only,
3. Select between
Evening & night or Always OFF .
Evening only will start the schedule for the
Note:
headlights at sunset and stop at midnight.
Evening & night will start the schedule for the
headlights at sunset and stop at sunrise.
To set the Flashes when fault function
The headlights flashes if the product stops to
operate because of a fault if
enabled.
To get access to the menu
1. Do steps 1–3 in
on page 23 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Headlights > Flashes when
fault .
3. Use the OK button to enable or disable the
Flashes when fault function.
Flashes when fault is
1220 - 001 -