Husqvarna Automower 310 Operator's Manual page 43

Message Cause
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
No drive
The product is caught in something.
The work area includes a steep slope.
The guide wire is not laid at an angle
on a slope.
Wheel motor over-
The product is caught in something.
loaded, right
Wheel motor over-
loaded, left
Charging station
The contact between the charging
blocked
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
Stuck in charging
There is an object in the way of the
station
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Needs manual
The product is set to the
charging area operating mode.
1220 - 001 -
Action
Enter the correct PIN code. Contact
your local Husqvarna representative if
you forget the PIN code.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Maximum guaranteed slope is 40%.
Steeper slopes should be isolated. Re-
To put the boundary wire in a
fer to
slope on page 18 .
If the guide wire is laid on a slope, it
must be laid at an angle across the
slope. Refer to
put the guide wire on page 19 .
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
Remove the object.
Turn the product the right way up.
Secondary
Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
To examine where to
Troubleshooting - 43