PG 720 Expansions
5.6
Closing the Unit
Closing the Unit
To close the unit, proceed as follows:
1. Tilt the unit to the horizontal position.
2. Place the front section on the casing at an angle (the guide studs at the top
3. Insert the CD-ROM ribbon cable into the drive connector on the
4. Press the front section onto the lower edge of the casing until the catches in
5. Insert the battery into the battery compartment and connect it up.
6. Close the battery cover.
7. Connect the keyboard connector to the back of the unit. Make sure that
8. Insert the keyboard cable in the cable conduit at the base of the device.
9. Allow the keyboard hinge to slide into the receptacles in the base of the
10. Tilt the unit back into the operating position.
Your PG 720 is now ready for operation again.
5-10
edge must fit into place).
backplane.
the base engage.
the cable is inserted in its channel.
device.
PG 720 P Programming Device
C79000-G7076-C721-02