Unpacking And Setting Up The; Setting Up The - Siemens SIMATIC PG 720 P Manual

Unpacking and Setting Up the PG 720
2.1 Setting Up the PG 720
Unpacking Your
Unpack your PG 720 as follows:
PG 720
1. Remove the packing.
2. Do not throw the original packing away. Keep it in case you have to ship
3. Check the packing list to make sure that no components are missing.
Caution
!
Risk of damage!
Moisture inside the unit can cause serious damage.
When transporting the unit in cold weather, when it may be submitted to
extreme variations in temperature, make sure that the unit is allowed to
reach room temperature slowly before you switch it on.
If condensation has formed, this must be allowed to evaporate before you
switch on. If, for example, the unit is subjected to a temperature change from
–20 C to +20 (–4 F to +68 F) you should wait approximately 12 hours
before switching on the unit.
Setting Up on a
The PG 720 is used primarily on a desk or table top. To ensure a comfortable
Desk Top
working position, the PG 720 can be adapted as follows to suit the work
place:
1. Place the PG 720 on the desk or table top.
2. Open the keyboard lock by pulling up the gray handle.
3. Lower the keyboard into position.
Figure 2-1
2-2
or transport the unit again at some time in the future.
The Programming Device before Opening
Handle
PG 720 P Programming Device
C79000-G7076-C721-02