Maintenance Of Painted Surfaces; Repainting The Scratched Areas; Tools And Materials - ABB PVS-100 Series Hardware Manual

Task
Clean the air filters by blowing compressed air
from the inside to the outside through the filter
until the dust comes off.
Loosen and remove the screws on the filter frame.
Clean the grill interior with a vacuum cleaner.
Install the filter support frames and tighten the
screws.
Turn OFF/OPEN the circuit breaker for fan.
Disconnect the supply and signal cabling.
Use compressed air to clean the fans.
Use a vacuum cleaner to clean the floor, doors
and interior metal beams.

Maintenance of painted surfaces

WARNING!
Obey the Safety instructions (page 9)
physical injury or death, or damage to the equipment may occur.
WARNING!
Obey the Safety instructions (page
primer and paint manufacture.
￭

Repainting the scratched areas

Tools and materials

Use the following tools and materials. If the listed tools are not available in your local market,
you can use products with similar characteristics approved by a qualified technician, and
get approval from ABB.
Tool
Flap Disc
Grinding machine
Flexible abrasive sponges
Degreasing sprays
Body shop putties
Rags or blower
Disposable gloves
Safety glasses
Additional information
Cleaning the air filters
Cleaning the fans
Prevent the circuit breaker from turning on acci-
dentally.
Measure to make sure that it is not energized.
Cleaning the MV switchgear area
If necessary, use a duster or pressurized air to
clean locations you cannot reach with the vacuum
cleaner.
and the local safety regulations. If ignored,
9), requirements and specifications of the
Specification
1 ud
1 ud
10 ud
250 ml
1 ud
200 gr
10 ud
1 ud
Maintenance 57
Make
Silver P80 Triton
Bosch
Ehs
-
Finissage, Impa
-
-
Uvex Astrospec