Suzuki SY413 Service Manual page 3378

IMPORTANT
WARNING/CAUTION/NOTE
Please read this manual and follow its instructions
carefully. To emphasize special information, the words
WARNING, CAUTION and NOTE have special mean-
ings. Pay special attention to the messages high-
lighted by these signal words.
WARNING:
Indicates a potential hazard that could result
in death or injury.
CAUTION:
Indicates a potential hazard that could result
in vehicle damage.
NOTE:
Indicates special information to make mainte-
nance easier or instructions clearer.
WARNING:
This service manual is intended for autho-
rized SUZUKI dealers and qualified service
mechanics only. Inexperienced mechanics
or mechanics without the proper tools and
equipment may not be able to properly per-
form the services described in this manual.
Improper repair may result in injury to the
mechanic and may render the vehicle un-
safe for the driver and passengers.
WARNING:
For vehicles equipped with Supplemental
Restraint (Air Bag) System:
D Service on or around the air bag system
components or wiring must be performed
only by an authorized SUZUKI dealer.
Refer to "Air Bag System Components
and Wiring Location View" under "Gener-
al Description" in air bag system section
in order to confirm whether you are per-
forming service on or near the air bag sys-
tem components
observe all WARNINGS and "Precau-
tions" in air bag system section before
performing service on or around the air
bag system components or wiring. Failure
to follow WARNINGS could result in
unintentional activation of the system or
could render the system inoperative. Ei-
ther of these two conditions may result in
serve injury.
D If the air bag system and another vehicle
system both need repair, SUZUKI recom-
mends that the air bag system be repaired
first, to help avoid unintentional air bag
system activation.
D Do not modify the steering wheel, instru-
ment panel or any other air bag system
component ( on or around air bag system
components or wiring). Modifications can
adversely affect air bag system perfor-
mance and lead to injury.
D If the vehicle will be exposed to tempera-
tures over 935C (2005F) (for example, dur-
ing a paint baking process), remove the
air bag system components air bag (infla-
tor) modules, sensing and diagnostic
module (SDM), seat belt pretensioner (if
equipped) beforehand to avoid compo-
nent damage or unintended activation.
or wiring. Please