Suzuki SY413 Service Manual page 3307

A: Align locator C, D: Match Marks
1. Magnetic switch 2. Plunger cover
1. Housing bolts
2. Rear bracket 5. Over-running clutch
3. Reduction gear assembly assembly
4. Drive lever 6. Front housing
A: Locator tab
1. Snap ring
2. Pinion stop ring
3. Over-running clutch assembly
DISASSEMBLY
NOTE:
Before disassembling starting motor, be sure to put match
mark at two locations (C & D) as shown in the left figure so that
any possible mistake can be avoided.
1) Remove magnetic switch and plunger cover.
NOTE:
Don't disassemble this switch. If defective, replace as a
complete assembly.
2) Remove housing bolts, then remove motor assembly with rear
bracket, reduction gear assembly (center bearing & shock ab-
sorber) with over-running clutch assembly and drive lever.
3) To overhaul reduction gear assembly, remove plate, planetary
gears and washer.
1. Plate
2. Internal gear
3. Planetary gear
4. center bearing &
shock absorber
5. Over-running clutch
6. Washer
4) Loosen pinion stop ring fixed by snap ring.
CRANKING SYSTEM 6G1-7