Fagor 8065 Error Solving Manual page 94

1876
DETECTION
CAUSE
SOLUTION
1877
DETECTION
CAUSE
SOLUTION
1878
DETECTION
CAUSE
SOLUTION
1879
DETECTION
CAUSE
SOLUTION
1880
DETECTION
CAUSE
SOLUTION
1881
DETECTION
CAUSE
SOLUTION
1882
DETECTION
CAUSE
SOLUTION
1883
DETECTION
CAUSE
SOLUTION
1884
DETECTION
CAUSE
SOLUTION
1885
DETECTION
CAUSE
SOLUTION
CNC 8060
1886
CNC 8065
DETECTION
CAUSE
SOLUTION
1887
(R : 1709)
EF
DETECTION
CAUSE
SOLUTION
·94·
'Pocket with islands: Wrong XY profile'
During the execution of the cycle.
Geometry of the surface profile programmed wrong.
Correct the geometry of the profile from the profile editor.
'Pocket with islands: Z profile does not exist'
During the execution of the cycle.
The programmed depth profile does not exist.
Select an existing profile or generate the programmed profile.
'Pocket with islands: Wrong finishing tool tip (nose) radius'
During the execution of the cycle.
The tip radius (Rp) of the finishing tool is greater than its radius ( R ).
Correct the tool tip (nose) radius.
'Pocket with islands: Wrong semi-finishing tool radius'
During the execution of the cycle.
The semi-finishing tool radius 0 or it is too large for the geometry of the pocket.
Correct the tool in the table or select another tool.
'Pocket with islands: Semi-finishing T missing'
During the execution of the cycle.
The programmed tool does not exist in the tool table.
Correct the tool in the table or select another tool.
'Pocket with islands: Wrong semi-finishing F'
During the execution of the cycle.
The semi-finishing feedrate is 0.
Define a feedrate higher than 0.
'Pocket with islands: Wrong semi-finishing S'
During the execution of the cycle.
The spindle speed for the semi-finishing operation is 0.
Define a speed higher than 0.
'Pocket with islands: Pocket already in execution'
During the execution of the cycle.
The CNC cannot simulate or execute the pocket because it is already in execution
or simulation.
Wait for the CNC to finish the simulation or execution.
'Pocket with islands: Arc programmed wrong in the profile'
During the execution of the cycle.
In some profile of the pocket, there is an arc that has been defined wrong or the profile
has been modified with a program other than the profile editor.
Correct the geometry of the profile from the profile editor.
'Pocket with islands: Wrong pocket geometry'
During the execution of the cycle.
In some profile of the pocket, there is a section that has been defined wrong (rounding,
chamfer, etc.).
Correct the geometry of the profile from the profile editor.
'Pocket with islands: Wrong roughing tool's penetration angle'
During the execution of the cycle.
The roughing penetration angle (parameter ) is not between 0º and 90º.
Correct the penetration angle; program a value between 0º and 90º.
'Pocket with islands: Wrong penetration angle of the semi-finishing tool'
During the execution of the cycle.
The finishing penetration angle (parameter ) is not between 0º and 90º.
Correct the penetration angle; program a value between 0º and 90º.
E r r o r so l v i n g m a n u a l .