Figure 1-1 Vmivme-7805/Vme-7805Rc Board Layout - GE VMIVME-7805 Hardware Reference Manual

Figure 1-1 VMIVME-7805/VME-7805RC Board Layout

E11
Boot Continuation Jumper
Install a shunt on Jumper E11
to load default settings and to
continue booting on a CMOS error.
CompactFlash
PMC Site
Memory
Module
COM
1 and 2 (J17)
Gigabit
Ethernet (J15)
10/100
Mbit (J14)
(J12)
USB Port
DVI
Connector (J10)
Mouse/
Keyboard (J16)
E3
CMOS Clear
Momentarily short the pins of E3
for approximately five seconds.
E 3
E 1 1
P 6
Pins 1 - 4: Open - Disable VMEbus SYSRST Driver
Pins 1 - 4: Closed - Enable VMEbus SYSRST Driver (D)
Pins 2 - 3: Open - Disable SYSRST Receiver
Pins 2 - 3: Closed - Enable SYSRST Receiver (D)
(D) Denotes: Default State.
J 1
P 1
J 2
J 3
S 6
S 7
E 1 2
P 2
S6
PMC Site
Connectors
Shown in the factory
default state.
S7
Pins 1 - 4: Open - Map Universe II in Memory Space (D)
Pins 1 - 4: Closed - Map Universe II to I/O Space
Pins 2 - 3: Open - Disable SYSFAIL Generation (D)
Pins 2 - 3: Closed - Enable SYSFAIL Generation
(D) Denotes: Default State.
NOTE: When the switch is in the
down position, it is open.
When the switch is in the
up position, it is closed.
Switch Example:
4 3
UP
(Closed)
DOWN
(Open)
1 2
Handling and Installation 15