ABB RMC-100 Startup Manual page 13

Figure 7 shows the side view of a TFIO module and its pinouts.
Table 8 to 13 identify the wiring pins for the TFIO M2 modules used with the RMC.
The wiring pins are the same for legacy TFIO modules.
CAUTION – Equipment damage. The output voltage at the following
pins is dependent upon the external power supply connected to the
CHARGER/EXT PWR port:
J2-1, J4-1 and J4-3 (Table 8) and J1-1, J2-1, J3-1, J4-1 (Table 9)
Before connecting to these pins, make sure that the external device is
compatible with the input voltage at the CHARGER/EXT PWR port.
J1
1 POINT 1 SIG
2 POINT 1 GND
3 POINT 2 SIG
4 POINT 2 GND
Table 9: TFIO analog output (4-20 mA) module (M2)
J1
1 AO1 Vdc source
2 AO1 Isink
3 AO1 Isource
4 AO1 Vdc common
Side View
Figure 7: TFIO module
Table 8: TFIO valve control interface module (M2)
J2
AO Vdc source
AO Isink
AO Isource
AO Vdc common
J2
AO2 Vdc source
AO2 Isink
AO2 Isource
AO2 Vdc common
M2
Pins
J3
POINT 3 SIG
POINT 3 GND
POINT 4 SIG
POINT 4 GND
J3
AO3 Vdc source
AO3 Isink
AO3 Isource
AO3 Vdc common
J4
POINT 5 SIG
POINT 6 SIG
POINT 7 SIG
POINT 8 SIG
J4
AO4 Vdc source
AO4 Isink
AO4 Isource
AO4 Vdc common
2105551-001 rev. AC | 13