Section 9 Troubleshooting
Troubleshooting
Do not open the analyzer to perform troubleshooting procedures.
Always use the Lockout/tag out procedure to power OFF the spectrometer. Refer
to
Lockout/Tag Out Procedure
Each time you perform a step of the flow chart (refer to
situation, reboot the system by closing and restarting the analyzer.
LED troubleshooting table
Upon powering up the analyzer, all LEDS should light up for a period of 10
seconds.
AA003700-01 rev. G. 2.0
Section 9 Troubleshooting
on page 10.
Troubleshooting
Table 9-
2) to correct a
39