Canon D1 Service Manual page 22

2
Technology > Controls (Reader)
Change
1A 1B
Yes Yes
No Yes
Yes No
No No
2. Priority on the front sensor
When checking the measurements for main scanning direction, if the absence of an original
is indicated at the rear while the presence of an original is indicated at the front, the machine
will give priority to the indication at the front.
Rear
side
Position of
detection 1
Position of
detection 2
Position of
B5
detection 3
Position of
detection 4
Front
side
CCD original
detection position
In case of B5 size original
Position of Result of detection
detection
1 Yes
2 No
3 Yes
4 No
2 Technology > Controls (Reader)
Result of detection
Original absence
Original presence
Original presence
Original presence
T-2-2
Original sensor 0
F-2-11
Result of
identification
Yes
Yes
Yes
No
T-2-3
● Detection Operation Overview
1) Standby state (The following is in case that the AB type, A4R size is set.)
CCD unit: shading position
LED: OFF
Original sensor: OFF
CCD unit
ADF
Reader unit
CCD original detection position
2) ADF opened
CCD unit: moves to original detection position
LED: OFF
Original sensor: OFF
(External
light)
3) ADF closed
CCD unit: in original detection position
LED: OFF to ON
Original sensor: in original detection operation
- With the ADF angle at 25 deg or less, the external light is blocked at the original width
area. Then, the machine determines that the original is absent at the points that the
external light is detected (external light search operation). When the original mount sensor
(rear) detects [close], original size detection is started. In this case, B5/B4/A4/A3 size is
eliminated at this point.
- After external light search, LED is turned ON at main scanning side and the CCD checks
the reflection light (4 points). For sub scanning direction, original sensor detects the size.
Original sensor
Position of detection 1
Position of detection 2
Position of detection 3
Position of detection 4
Copyboard glass
F-2-12
F-2-13
2-7
2-7