Figure 47: Communication Setup For Totalflow /Tcp Protocol (Default Tcp Port) - ABB XSeriesG4 User Manual

Figure 47: Communication setup for Totalflow /TCP protocol (default TCP port)

Click Send to save changes.
Open the door to the flow computer.
Press the Reset button on the board. This restarts the XRC with the Ethernet port enabled. The current PCCU connection
to the XRC over the serial or USB port may terminate as the XRC resets.
When the XRC completes its startup sequence, connect to the XRC using Ethernet as described in section 3.4.2,
Establish local point-to-point connection over Ethernet.
Establish local point-to-point connection over Ethernet
To establish an Ethernet connection:
Make sure the Ethernet cable is connected to both the XFC and laptop Ethernet ports.
Restart PCCU.
Click Setup from the toolbar. The Setup screen for communication displays (Figure 48).
48