Port Description - Huawei SmartLogger2000 series Quick Manual

1.2

Port Description

SmartLogger2000-10-C/11-C
No. Port (Silk Screen)
1 RF1, RF2
2 12V OUT
3 12V IN
4 USB
5 SFP1, SFP2
6 ETH1, ETH2
7 DO
8 COM1–COM6
9 Default
a
10 AC1, AC2
11
12 AI1–AI7
13 PT1, PT2
14 AO1–AO4
15 DI1–DI8
Note a: When the SmartLogger is applied in a non-smart array controller, connect the AC1 and AC2
ports to the SPD with the delivered cables. The residue voltage of the SPD should be less than 6 kV.
Note b: Passive means that the AI port can connect to a sensor that needs to be energized separately.
Function
Reserved Reserved.
Provides 12 V DC power supply with a maximum
12 V DC output
current of 100 mA.
12 V DC input Connects to the power adapter.
USB port Connects a USB flash drive.
Connects to an ATB or another cascaded
Ethernet optical port
SmartLogger.
Ethernet electrical Connects to an Ethernet LAN switch, router, POE or
port PC device.
Digital output (DO) Relay output supports 12 V voltage and 0.5 A current.
Six RS485 ports that can be connected to devices
RS485
such as the SUN2000, box-type transformer, power
communications
meter, or EMI.
Resets and restarts the Bluetooth module or resets
the SmartLogger IP address to the default IP address
Default key
(valid within 5 minutes). The default IP address is
192.168.0.10.
SmartLogger2000-10-C: Connects to three-phase (A,
AC power cable B, and C) inputs, and is used for PLC with the
ports SUN2000 over AC power cables.
SmartLogger2000-11-C: disabled
Shell ground point N/A
AI1 supports 0–10 V input voltage (passive
Analog input
support 0–20 mA and 4–20 mA input current (passive).

Analog input

Analog output (AO) 4–20 mA and 0–20 mA output current
Connects to a dry contact input. GND1 and GND2 are
Digital input (DI)
ground ports for DI signals.
Description
PT1 supports the connection to a three-wire or two-
wire PT100/PT1000 temperature sensor.
PT2 supports the connection to only a two-wire
PT100/PT1000 temperature sensor.
2
b
); AI2–AI7