Appendix; Troubleshooting - Sanyo PLC-XP200L Owner's Manual

Troubleshooting

Before calling your dealer or service center for assistance, check the items below once again.
1. Make sure you have properly connected the projector to peripheral equipment as described on pages 22–24.
2. Check the cable connection. Make sure that all computers, video equipment, and power cords are properly
connected.
3. Make sure that all power is switched on.
4. If the projector still does not produce an image, restart your computer.
5. If an image still does not appear, disconnect the projector from your computer and check your computer
monitor's display. A problem may be noticed with your graphics controller rather than with the projector.
(When you reconnect the projector, be sure to turn the computer and monitor off before you turn on the
projector. Turn on equipment in the order of the projector and computer.)
6. If a problem still persists, check the following solutions.
Problem:
No power.
PIN code dialog box
appears at start-up.
The initial display is not
shown.
The initial display is not
same with the default
one.
When the projector is on
and you press the input
button, an icon other
than the Lamp mode icon
appears.
An icon other than Input
mode or Lamp mode icon
appears.
No image.
appears on the screen

Appendix

Solutions
– Plug the power cord of the projector into the AC outlet.
– Wait until the POWER indicator stops blinking to turn on the projector again. (See
page 26)
– Check the WARNING TEMP . indicator. If the WARNING TEMP . indicator is blinking, the
projector cannot be turned on. (See page 68.)
– Unlock the Key lock function for the projector. (See page 57)
– See if the filter cartridge is inserted. (See page 62)
– Check the projection lamp. (See page 64.)
– PIN code lock is being set. Enter a PIN code; the "1234" or numbers you have set
(See pages 26, 57-58)
– Make sure "Off " or "Countdown Off" are not chosen at Display function.
(See "SETTING" section on page 52)
– Make sure "User" or "Off" are not chosen at Logo select function.
(See "SETTING" section on page 53)
– That is the Filter warning icon. (See page 61.)
– That is the Lamp replacement icon or the Filter warning icon. (See page 60-61.)
– Check the connection between your computer or video equipment and the projector.
– See if the input signal is correctly output from your computer. Some laptop
computers may need to be changed the setting for monitor output when connected
to the projector. See your computer's instruction manual for the setting.
– It takes about 30 seconds to display an image after turning on the projector.
– See if the selected system is corresponding with your computer or video equipment.
– Select correct input source once again through menu operation (See pages 35-37).
– Make sure the temperature is not out of Operating Temperature (41˚F–104˚F [5˚C–
40˚C]).
– End of lamp life is approaching. Replace the lamp with a new one promptly. (See
pages 59, 64-65)
69