Sanyo PLC-XP200L Owner's Manual page 55

Lamp control
This function allows you to change the brightness of the screen.
Auto . . . . . Brightness according to the input signal.
Normal . . . Normal brightness.
Eco 1. . . . . Lower brightness and Fan control set to Normal.
Lower brightness reduces the lamp power
consumption and extends the lamp life.
Eco 2. . . . . Lower brightness and Fan control set to Max.
Lower brightness reduces the lamp power
consumption and extends the lamp life. It is
recommended to use Eco 2 when using the
projector continuously over a long period of time.
The fan noise becomes louder in Eco 2 than in
Eco 1. Select the suitable mode for the used
environment.
Filter control
You can replace the filter with this function. Press the SELECT
button at Filter control to display a confirmation box. To replace,
press the SELECT button at "YES" and the electrically operated
filter starts to scroll.
You can also replace the filter by using the remote control (p. 33).
Fan control
Choose the running speed of cooling fans from the following
options.
Normal ....... Operate in this mode under normal conditions.
Max ........... Use this mode when you want to increase the
cooling effect when operating the projector in high
ambient temperature environment. Fan noise is
louder than "Normal" .
Remote control
This function allows you to change the Simple mode and RC code
setting on the remote control.
Simple mode
This function decides whether to activate the simple mode.
Off . . . . Simple mode function is off.
On . . . . Only the simple mode buttons are active.
RC code
The eight different remote control codes (Code 1–Code 8) are
assigned to the projector; the factory-set, initial code (Code 1) and
the other seven codes (Code 2 to Code 8). After selecting the RC
code, move the red arrow pointer to the Quit icon and press the
SELECT button to set the RC code.
The same code should set on both the projector and the remote
control. For example, operating the projector in "Code 7" , the
remote control code also must be switched to "Code 7" .
To change the code for the projector:
Select a remote control code in this Setting Menu.
To change the code for the remote control:
Press and hold the MENU button and a number button (1–8) on
the remote control for more than five seconds to switch between
the codes (p. 17).
✔ Note:
• Filter replacement icon and "Please wait... "
message appear on the screen when the
filter is being scrolled.
• The filter cannot be rewound.
• When the filter is replaced, the total
accumulated time of the filter use is
automatically set to 0.
Remote control
When pressing the SELECT button at
Remote control, the Remote control
menu appears.
Simple mode buttons
Only these buttons are active
when the simple mode is set to
"On. " [ON, STAND-BY, INPUT,
AUTO PC, INFO., MENU, SCREEN,
SHUTTER, ed7 8, SELECT,
VOL.+, VOL.-, MUTE, RESET/ON/
ALL-OFF switch]
✔ Note:
• If you do not select the Quit icon and exit
the Remote control menu, the RC code will
not be set.
Setting
Quit
55