Sanyo PLC-XP200L Owner's Manual page 53

Background
The selected background screen will be displayed when no input
signal is detected.
Blue . . . Blue colored background.
User . . . The image you captured.
Black. . . Black colored background.
Logo
This function allows you to customize the screen logo with Logo
select, Capture, and Logo PIN code lock functions.
✔ Note:
• When "On" is selected in the Logo PIN code lock function, Logo
select and Capture functions cannot be selected.
Logo select
This function decides on the starting-up display from among the
following options.
User . . . Show the image you captured.
Default . Show the factory-set logo.
Off . . . . Show the countdown display only.
Capture
This function enables you to capture an image being projected to
use it for a starting-up display or interval of presentations.
Select Capture and press the SELECT button.
A confirmation box appears and select [Yes] to capture the
projected image.
After capturing the projected image, go to the Logo select
function and set it to "User" . Then the captured image will be
displayed the next time you turn on the projector.
To cancel the Capture function, select [No].
✔
Note:
• Before capturing an image, select
Select Menu to capture a proper image. (pp. 42, 46)
• A signal from a computer can be captured up to XGA (1024 X
768).
• Certain signals may not be captured properly.
• When capturing the image that has been adjusted by the
Keystone function, the adjusted data is automatically reset and
the projector captures an image without keystone correction.
• When starting to capture a new image, the previously stored
image is cleared even if you cancel the capturing.
• Once you exit the Logo Menu after setting the Logo lock to
"On," you are required to enter the PIN code every attempting to
change the Logo setting.
• "User" cannot be selected when the image is not captured.
" "
Standard in the Image
✔ Note:
• "User" cannot be selected when the image is
not captured.
Logo
Set the red frame pointer
to the item and press the
SELECT button.
Select [Yes] to stop
capturing.
Capture
Set the pointer (red
arrow) to the item and
press the SELECT button.
Setting
Select [Yes]
to capture
the projected
image.
53