Nokia 7368 ISAM ONT G-240W-C Product Manual page 99

7368 ISAM ONT G-240W-C Product Guide
(2 of 2)
2
3
4
Procedure 26
The US Classifier feature is used to create policies, classifiers, and classifier rules for upstream
traffic handling. This feature is available to admin users (super users) only.
A policy defines an action to be performed on a set of LAN or WAN packets. A policy can be
created at any time and then subsequently assigned to one or more classifiers.
A classifier is used to select key fields for which the classifier rules will be written. A classifier can
be created at any time and then subsequently assigned to one or more classifier rules.
A classifier rule is used to assign actions to a group of packets based on a set of parameters. A
classification rule must be created against a pre-defined classifier.
Up to 16 policies can be created, with up to 8 classifiers and 32 classifier rules.
1
Issue: 01
R05.05.01 | December 2016 | 3FE 46690 AAAA TCZZA | Edition 01
Field
Primary Remote End
Secondary Remote End (optional)
Connected Remote End
Failover mechanism
Traffic timeout to start pings
No. of retries before unreachable
Configure the GRE tunnel by entering or selecting the required information.
Click Save.
STOP. This procedure is complete.
Upstream (US) Classifier configuration
Select Network > US Classifier from the top-level menu in the GPON Home Gateway
window, and select the Policy tab, as shown in Figure 44.
All classifier policies are displayed in the policy table in the window.
Configure a G-240W-C indoor ONT
Description
Enter an IP address or FQDN that is unique in the system.
If the primary remote endpoint is down or unreachable, the secondary
remote endpoint becomes active, if configured.
The secondary remote endpoint remains active until it becomes
unreachable, in which case the primary remote endpoint becomes active
again. Revertive mode is not supported.
If both endpoints are unreachable, the GRE tunnel is declared down.
This field displays the current data traffic path for the GRE tunnel.
This feature is automatically selected by the system.
Enter the traffic timeout in seconds (0 to 100).
Enter the number of retries before the tunnel is declared down (2 to 1024).
Edition 01 99