Beta Marine Beta 14 Installation Manual page 43

Depending on engine fuel filter type follow either
steps 6 & 8 or steps 7 & 8.
6. Move the hand priming lever on fuel lift pump up and
down (please refer to image 42) until fuel with "no
bubbles" come out of the fuel filter bleed bolt (please
refer to image 40). The hand priming lever normally
has about 90° travel: but the camshaft lobe may
block this travel requiring you to rotate the
engine crankshaft 90° to obtain full travel.
42
Hand priming
lever
The hand priming lever or button will be located:
Beta 10, 14, 16, 20 & 25
Mid engine, starboard side when viewed from the gearbox
end.
Beta 30, 35, 38 & 45T
Forward end, starboard side when viewed from the gear-
box end.
Beta 43, 50 & 60
Mid engine, starboard side under the morse control
bracket.
7. Move the hand priming button on the fuel filter until
fuel with "no bubbles" come out of the fuel filter bleed
bolt, please refer to image 43.
8. Shut/tighten the fuel filter bleed bolt, please refer to
image 40 or 41.
43
Beta 70T, 75, 85T, 90, 90T, 105T & 115T
The hand priming button is located on the top of the fuel
filter assembly.
41
Hand priming
button