Suzuki Grand Vitara Service Manual page 47

Tooth Contact Pattern
I5JB0A321041-05
IYSQ01321072-01
IYSQ01321074-01
IYSQ01321077-01
IYSQ01321078-01
IYSQ01321079-01
www.CarGarage.ir
Diagnosis and Remedy
Normal
High Contact
Pinion is positioned too far from the center of drive
bevel gear (1).
• Increase thickness of pinion (2) height adjusting
shim and position pinion closer to gear center.
• Adjust drive bevel gear backlash to specification.
Low Contact
Pinion is positioned too close to the center of drive
bevel gear (1).
• Decrease thickness of pinion (2) height adjusting
shim and position pinion farther from gear center.
• Adjust drive bevel gear backlash to specification.
If adjustment is impossible, replace differential carrier.
• Check seating of bevel gear or differential case. (Check bevel
gear for runout.)
• If adjustment is impossible, replace drive bevel gear and pinion
set or differential carrier.
Replace drive bevel gear and pinion set or differential case.
www.CarGarage.ir
Differential: Rear 3B-34
IYSQ01321073-01
IYSQ01321076-01