NEC Express 5800 Series User Manual page 42

Keyword
configurationmode
connectionname
controller
ctrlpath
degradedperformancemode
drivetype
drivewritecache
elevatorsort
enclosure
exitonerror
expandpriority
inconsistencyrepairpolicy
licensekey
logicaldrive
mnpdelay
*The CLI also uses this keyword and abbreviation for the terms box name and RAID array ID.
The show command
The show command enables you to obtain information about a device.
Syntax:
<target> show [detail]|[status]
When you specify a target that consists of several devices, the information in the output is normally less
comprehensive than when you specify only one device as the target. You can use the [detail] parameter in
this case to retain all the information usually given for individual devices.
An extra parameter is available for controller targets: config. This parameter is used as follows:
<target controller> show config [detail]
If you use the config parameter, the output includes information about each device connected to the
controller.
Example 1:
=> ctrl slot=0 show
A typical output would be:
HPE Smart Array P408i-a SR Gen10 in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Serial Number: PEYHC0XRH570YT
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Hardware Revision: B
Firmware Version: 0.01-868
Rebuild Priority: High
Expand Priority: Medium
Surface Scan Delay: 3 secs
Surface Scan Mode: Idle
Parallel Surface Scan Supported: Yes
Current Parallel Surface Scan Count: 1
Max Parallel Surface Scan Count: 16
Keyword
Abbreviation in
SSA CLI
cm rebuildpriority
cn serialnumber
ctrl spareactivationmode
cp ssdoverprovisioningoptimizati
on
dpo ssdphysicaldrive
dt stripesize
dwc surfaceanalysiseventnotify
es surfacescandelay
enc surfacescanmode
eoe sufacescanpriority
ep tapedrive
irp waitforcacheroom
lk —
ld —
mnpd —
Abbreviation in
SSA CLI
rp
sn
sam
ssdopo
ssdpd
ss
saen
ssd
ssm
sp
td
wfcr
—
—
—
SSA CLI 42