Sanyo TUHD5500HDD User Manual page 10

There are many different types of TV/VCR and other equipment that you can connect to
your Set Top Box. Shown below are the most common methods normally used. If you
have problems with your connections, contact your retailer as soon as possible.
Connecting to the TV via HDMI/ YPbPr
This method is recommended for the best picture quality.
Note: Cables are not supplied with the Set Top Box. Make sure that both the TV and the
Set Top Box are switched off at the power outlet before connection.
This method is recommended for the best picture quality.
Note: Cables are not supplied with the Set Top Box. Make sure that both the TV and the
Set Top Box are switched off at the power outlet.
Connect ANT OUT1 to ANT IN2 with the RF loop cable
•
Connect the antenna to the ANT IN1 of the Set Top Box.
•
Connect the ANT OUT2 of the Set Top Box to the RF input of the TV.
•
Connect the HDMI/YPbPr/R+L outputs of the Set Top Box to the inputs of the TV if
•
available.
Turn on the Set Top Box and the TV.
•
Select the HDMI or Component input mode on TV.
•
Change Set Top Box signal by remote control HDMI S, HDMI.INPUT1 or HDMI.
•
INPUT2 will be delivered through HDMI.OUTPUT to TV.
Optional audio connections
Instead of connecting the Left and Right Audio outputs to your TV, they can be connected
to your Hi-Fi stereo for better sound quality. In this case, connect the Left and Right Audio
outputs from the Set Top Box to the Left and Right Audio inputs on your Hi-Fi Stereo. If
you have a home theatre receiver with built in DolbyTM digital decoder, then connect the
SPDIF output (coaxial or optical) of the digital TV Set Top Box to the SPDIF input of your
home theatre receiver.
7
7. Setup