GE D30 Instruction Manual page 666

REVISION HISTORY
Table D-6: Major changes for D30 manual version AC1 (English)
Page Description
--- General revision. Added online help and updated generic online help.
--- Deleted EAC logo from title page and deleted EAC certification from Approvals specifications because document not
translated into Russian
--- Updated Breaker Arcing Current content, including FlexLogic operands table, settings, logic diagram, actual values, Modbus
memory map
--- Updated Synchrocheck content including settings, logic diagram, and number of elements from four to six in interface
chapter, FlexLogic operands table, settings, actual values, FlexAnalog table, features per product table, Modbus memory map,
IMD tables
--- Updated Fault Report and Fault Location content, including settings, actual values, and theory of operation chapters
--- Added support for two Wattmetric Zero-Sequence Directional / Wattmetric Ground Fault elements to product description,
specifications, FlexLogic operands table, settings, actual values, features per product table, Modbus memory map, and IMD
content
--- Added Data Logger content to product description, specifications, settings, actual values, commands, Modbus memory map,
IMD table
--- Added Frequency Rate of Change content to product description, specifications, FlexLogic operands table, settings, actual
values, FlexAnalog table, features per product table, Modbus memory map, IMD table
--- Added Incipient Cable Fault Detector content to product description, specifications, FlexLogic operands table, settings, actual
D
values, features per product table, Modbus memory map, IMD table
--- Added CT Failure Detector content to product description, FlexLogic operands table, settings, features per product table,
Modbus memory map, IMD table
--- Added Underfrequency content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Update Neutral Instantaneous Overcurrent number from 4 to 2 in FlexLogic operands table, settings, features per product
table, Modbus memory map
--- Updated number of Phase Instantaneous Overcurrent elements in FlexLogic operands table, settings, features per product
table, Modbus memory map
2-2 Updated Figure 2-1 single-line diagram
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-49 Updated IEC 61850 section
5-61 Added Support for Routable GOOSE section
5-167 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
5-191 Updated Zone 1 to 3 ground distance logic diagram to include IG
10-1 Added Monitoring section
10-2 Added Retrieve Files section
C- Added Command Line Interface appendix
D-4 D30 LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
APPENDIX D: MISCELLANEOUS