Replacing An Smu - Huawei ETP4830-A1 User Manual

ETP4830-A1
User Manual
Step 3 Gently draw the handle outwards, and then remove the rectifier from the subrack, as shown in
Figure
Figure 7-1 Removing a rectifier
Step 4 Push the locking latch on the new rectifier towards the left, and pull out the handle.
Step 5 Place the new rectifier at the entry to the correct slot.
Step 6 Gently slide the rectifier into the subrack along the guide rail, and lock the handle, as shown
in Figure
Figure 7-2 Installing a rectifier
Step 7 Take off protective gloves.
----End
Follow-up Procedure
Send the replaced rectifier for repair.

7.4.2 Replacing an SMU

Prerequisites


Issue 06 (2014-02-20)
7-1.
7-2.
Prepare an ESD wrist strap, a pair of protective gloves, an ESD box or bag.
Check that the new rectifier is intact.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Maintenance
52