Canon iPF6100 Service Manual page 657

Display massage
Cannot print 03010000-2E1F
as specified.
Press Load/Eject
and replace paper
with A4/LTR
(vertical) or larger
Cannot print 03010000-2E1F
as specified.
Press Load/Eject
and replace paper
with A3/11"x17"
(vertical) or larger
Cannot print 03010000-2E1F
as specified.
Press Load/Eject
and replace roll
with 10 in. wide or
larger roll.
Cannot print 03010000-2E1F
as specified.
Press Load/Eject
and replace paper
with A2/16.6"x23.4"
(vertical) or larger
Cannot feed paper. 03010000-2E25
Remove paper and
press Load/Eject.
Cannot detect papr 03010000-2E25
Remove paper and
press Load/Eject.
Cannot load. 03010000-2E27
Press Load/Eject
and reload the
paper.
This paper 03010000-200E
cannot be used.
Check supported
paper sizes.
Load/Eject:
Change Paper
This paper 03010000-200F
cannot be used.
Check supported
paper sizes.
Load/Eject:
Change Paper
No sheets. 03010000-2016
Press Load/Eject
and reload the
paper.
Use another paper. 03010000-2F33
Press Online to
clear the error.
Paper loaded 03016000-2010
askew.
Press Load/Eject
and reload the
paper.
Hardware error. 03130000-2E21
03130000-2E21
Turn off printer,
wait, then
turn on again.
Wrong paper type. 03061000-2E15
Stop: Stop Printing
Load/Eject:
Change Paper
Code* Condition detected
Undersized paper loaded for internal
printing (A4 or larger)
Undersized paper loaded for internal
printing (A3 or larger)
Undersized paper loaded for internal
printing (roll media)
The first sheet used for adjustment
printing or the like was A2 or larger-
sized but the second sheet used was
smaller than A2.
Feeding error
Paper jam while feeding/ejecting/
printing
Paper jam during feeding/printing/
ejection
Undersized paper (cut sheets/roll
media)
Oversized paper (cut sheets/roll media) Replace with smaller-sized paper.
Paper worked out of position while
printing
Unadjustable because of transparent
media
Skew
IEEE1394 interface error
The first and second sheets used for
adjustment printing or the like differed
in paper type.
Action
Replace with A4/Letter or any larger-sized paper.
Replace with A3/11"x17" or any larger-sized paper.
Replace with roll media at least 10 inches in width.
Prepare about 10 sheets of A2 or larger-sized paper.
Replace with A2 or any larger-sized paper.
Remove the paper jam and reload the paper.
Remove the paper jam and reload the paper.
Reload the paper.
Replace with larger-sized paper.
Reload the paper
Replace with adjustable media.
Correct the skew in the paper and reload it.
Check that the optionalIEEE1394 board is mounted.
Check the cable connection.
Prepare paper of the same type as used for the first
sheet for adjustment printing or the like.
Chapter 8
8-9