31
Cable Connector for Gimbal Unit
32
TC Output Terminal (BNC)
Connect the [TC OUT] terminal of the master
device with the [TC IN] terminal of the slave
device.
33
TC Input Terminal (BNC)
Connect a time code signal generator to
synchronize with the SMPTE/EBU LTC time
code. When using as slave unit, connect the
[TC OUT] terminal of the master device.
Synchronization with the external time code
can be attained by inputting the external time
code to the TC input terminal and setting
[TC/UB] [TC Generator] to "Free Run".
34
Genlock Terminal (BNC)
Input external synchronizing signals, and
synchronize the camera video or playback
image with the external signal.
■
Synchronizing signal used
SD synchronizing :
signal
HD synchronizing :
signal
■
Phase Items to Synchronize
The phase items to be synchronized may vary
depending on the input synchronizing signal
and output video signal.
Output Video Signal
60p/50p (SDI OUT)
60i/50i (SDI OUT)
30p/25p (SDI OUT)
24p (SDI OUT)
60i/50i (AV OUT)
31
BB (Black Burst) signal
Supports SMPTE170M
(RS-170A)-NTSC
Supports ITU-R BT.470-6 PAL
HDTV tri-level synchronizing
signal
Input Synchronizing
Signal
Tri-sync
1080/
1080/
1080i
30p
25p
V
V
H, V, F
V
V
H, V
−
−
H, V
V, F
V
38
Memo :
When the camera system's video is locking
●
to the external synchronizing signal, "Sync
Locking" appears on the screen.
After locking to the external synchronizing
●
signal is complete, the display disappears
and recording can be performed.
If genlock is disconnected due to reasons
●
such as no signal input while genlock is in
operation, "Sync Unlocked" is displayed.
If there is genlock signal input but the signal
●
format is not supported, "Invalid Sync" is
displayed.
35
USB Host Terminal
Future upgrade will allow use of this.
36
AUX Input Terminal ( Φ 3.5 mm)
37
USB Mini Terminal
Memo :
Operation by the control unit is required to
●
switch to the USB mode.
38
Audio Input Terminal 1, 2
(XLR 3pin x 2)
BB
1080/
24p
24psF
*1
*1
V
*1
*1
V, F
*1
*1
V
−
V
*1
*1
H, V, F
27
37
36
35
32
33
34
H : Horizontal Phase
V : Vertical Phase
F : Field Phase
*1: Out of phase