Upper Housing Support Assy - Epson L1800 Service Manual

L1800
Be careful not to damage the surface in step 3 and later.
C A U T I O N
3. Remove the Printer Cover Holder Right following the steps below.
3-1. With the Printer Cover open, put the Upper Housing with the rear side up.
When performing the following steps, be careful not to damage the
C A U T I O N
tabs of the Printer Cover Holder Right.
3-2. Slide the Printer Cover Holder Right in the direction of the arrow while
lifting it, and remove the Printer Cover Holder Right from the Upper
Housing.
Upper Housing
Figure 3-28. Removing the Printer Cover
4. While holding the Printer Cover, remove the Printer Cover Holder Left in the same
manner as Step 3-2, and remove the Printer Cover from the Upper Housing.
Disassembly And Assembly
Printer Cover
Tab
Holder Right
Printer Cover
Removing the Housings
After replacing the following parts, be sure to apply G-26 grease to the
A D J U S T M E N T
R E Q U I R E D
area specified for each part.
 Printer Cover Holder Left: Chapter 5
 Printer Cover Holder Right: Chapter 5

3.2.8 Upper Housing Support Assy

1. Remove the Upper Housing / Printer Cover. (p.50)
2. Remove the two C.B.S. M3 x 6 screws and two C.B.P. M3 x 10 screws that secure
the Upper Housing Support Assy, and remove the Upper Housing Support Assy.
4
1) C.B.P. M3x10
(6±1 kgf.cm)
2) C.B.S. M3x6
(6±1 kgf.cm)
2
Upper Housing Support Assy
Figure 3-29. Removing the Upper Housing Support Assy
 Secure the Grounding Plate with one of the C.B.S. M3 x 6
screws together with the Upper Housing as shown below.
 Tighten the screws in the order shown in
Revision A
See Figure 5-13 (p.139).
See Figure 5-13 (p.139).
3
1) C.B.P. M3x10
(6±1 kgf.cm)
1
Figure 3-29.
52
Confidential