Modifying And Adapting The Simulation Graphics - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining

5.8 Modifying and adapting the simulation graphics

+
5.8 Modifying and adapting the simulation graphics
5.8.1 Enlarging or reducing the graphical representation
Precondition
The simulation or the simultaneous recording is started.
Procedure
...
136
Press the <CTRL> and <S> keys simultaneously to enable and
disable the single block mode.
1. Press the <+> and <-> keys if you wish to enlarge or reduce the
graphic display.
The graphic display enlarged or reduced from the center.
- OR -
Press the "Details" and "Zoom +" softkeys if you wish to increase the
size of the segment.
- OR -
Press the "Details" and "Zoom -" softkeys if you wish to decrease the
size of the segment.
- OR -
Operating Manual, 03/2010, 6FC5398-6AP10-4BA0
Universal