Pc Terminal Connection; Figure 5.3 Pc Terminal Connection For Initial Setup - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 5 General Settings
5.1

PC Terminal Connection

5.1 PC Terminal Connection
Connect a PC terminal to the ETERNUS AF.
Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the controller enclosure directly with the
LAN cable (for operation management).
For the setup information of the PC terminal, refer to
The ETERNUS AF and the PC terminal must be connected directly since the network environment of the
ETERNUS AF is set using the PC terminal for the initial setup of the ETERNUS AF.

Figure 5.3 PC Terminal Connection for Initial Setup

PC terminal
Controller enclosure
LAN port
LAN cable
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
"3.3 Preparing the PC Terminal for Setup" (page
RMT port of Controller 0 (CM#0)
58
40).
P3AG-1832-04ENZ0