Audit Log Setup - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 6 Monitoring Settings
6.4

Audit Log Setup

6.4 Audit Log Setup
Audit trail logs (hereinafter referred to as "audit log") that record performed operations by using the ETER-
NUS AF and the system actions that are associated with these operations can be sent to the specified Syslog
server (external server).
Up to two Syslog servers can be set.
•
After the environmental settings for audit logs are complete, confirm that the audit log is successfully
•
received on the Syslog server.
Even if a communication error occurs between the ETERNUS AF and the Syslog server, the audit log is
•
not sent again.
The audit log setting is explained below.
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Audit Log].
The [Audit Log] screen appears.
3
If "Disable" is specified for "Audit Log", select "Enable".
(1)
Click [Enable Audit Log] in [Action].
A confirmation screen appears.
(2)
Click the [OK] button.
Enabling of the audit log starts.
(3)
Check the setting completion message and click the [Done] button.
The screen display returns to the [Audit Log] screen.
4
Specify the Syslog server to which the audit log is sent.
(1)
Click [Setup Audit Log] in [Action].
The [Setup Audit Log] screen appears.
Select "on (RFC3164)" or "on (RFC5424)" for "Send Audit Log".
•
To send messages in RFC5424 format to a target Syslog server that supports RFC5424, select
"on (RFC5424)". If this is not the case, select "on (RFC3164)".
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
100
P3AG-1832-04ENZ0