Chapter 5
General Settings
This chapter explains how to set up the ETERNUS AF.
■
Initial Settings after Installation
The following settings must be performed when an ETERNUS AF is installed.
●
Storage Management
Perform the device information settings and the network connection settings All of the required settings can
be performed by following the instructions that are displayed when the Initial Setup 1 wizard is used.
●
Firewall Settings
Select whether to enable or disable connections for each service that is to be used via the LAN for operation
management.
●
RAID Configuration Settings
Register the RAID groups, the volumes, and the hot spares in the ETERNUS AF.
●
Monitoring Settings
Perform the settings to enable constant monitoring of the storage system status. For details on these set-
tings, refer to
●
Power Control Setup
Perform the storage system power control settings. For details on these settings, refer to
Control Setup" (page
●
SAN Connection Settings
Perform the settings for SAN connections with the server. For details on these settings, refer to
8 SAN Connection Settings" (page
●
Advanced Copy Settings
Perform the basic settings to use the Advanced Copy function. For details on these settings and performing
SnapOPC+, refer to
"Chapter 6 Monitoring Settings" (page
105).
109).
"Chapter 9 Advanced Copy Settings" (page
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
85).
141).
55
"Chapter 7 Power
"Chapter
P3AG-1832-04ENZ0