Hitachi HT-4139-28 Maintenance Manual page 77

REV0 10.02.15
8.3.5 Replacing the Scanner ASSY
Disconnect
it straight
make sure to connect it straight into the device
Bind-head screw
Eject Guide
#26 SS P/K ASSY（CPS618 P/K）
Bind-he ads screw
#64 LAMP INVERTER
-H8-14-
Bind-heads screw
Bind-heads screw
Bind-head screw
Bind-head screw Plate(DRV2 )
CAUTION CAUTION
CAUTION CAUTION
When connecting the mirror motor connector, make sure
to connect it straight into the device.
Tools Needed: Magnetic Philips Screwdriver (No.2)
①Remove the Main Cover (L), (R) Side Cover
(R). For instructions, please refer to "8.1
Preparation"
②Unscrew 4 screws on the Eject Guide and
remove the Eject Guide
③Remove the Imprinting ASSY. For instructions,
please refer to "8.3.9 Replacing the Imprinting
ASSY (Imprinting Head)"
④Unscrew 4 bind-head screws on the Plate
(DRV2)
⑤ Disconnect 2 connectors (J71, J72) attached to
the Lamp Inverter
⑥ Disconnect 2 connectors (J101, J102) attached
to SS P/K ASSY (CPS618 P/K)
⑦ Disconnect cable from the Clamp
⑧ When removing the Plate (DRV 2), push the
cable to the side so it does not get damaged.
⑨ Remove Cover Sheet assembly. For
instructions, please refer to "8.3.14 Replacing
the Cover Sheet assembly"
⑩ Remove Lamp ASSY (Front). For instructions,
please refer to "8.2.3 Replacing the Fluorescent
Lamp"