Peer Ipsec-Policy (Ipv6 Address Family View); Peer Keep-All-Routes (Ipv6 Address Family View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 ipv6-prefix list1 export

peer ipsec-policy (IPv6 address family view)

Syntax
peer { group-name | ipv6-address } ipsec-policy policy-name
undo peer { group-name | ipv6-address } ipsec-policy
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv6 peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
policy-name: IPsec policy name, a string of 1 to 15 characters.
Description
Use peer ipsec-policy to apply an IPsec policy to an IPv6 BGP peer or peer group.
Use undo peer ipsec-policy to remove the applied IPsec policy.
By default, no IPsec policy is applied to any peer or peer group.
The IPsec policy to be applied must have been configured. Otherwise, the configuration fails.
You also need to make IPsec policy configuration on the peer or peer group. Otherwise, the local
device will not receive IPv6 BGP packets from the peer or peer group.
Examples
# Apply IPsec policy policy001 to IPv6 BGP peer 1212::1111.
<Sysname] system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1212::1111 ipsec-policy policy001

peer keep-all-routes (IPv6 address family view)

Syntax
peer { group-name | ipv4-address | ipv6-address } keep-all-routes
undo peer { group-name | ipv4-address | ipv6-address } keep-all-routes
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
391