Start-Up; General Safety Information - Siemens SIMOREG DC Master 6RA7028-6DS22 Operating Instructions Manual

02.00
7

Start-Up

7.1 General safety information for start-up
DANGER
Before commencing with start-up on the converters (90A to 600A), make sure that the
transparent terminal cover is mounted in the correct position (see Section 5.1).
NOTE
Before handling any boards (in particular, the A7001 electronics board), please make sure that
your body is electrostatically discharged to protect electronic components against high voltages
caused by electrostatic charges. The simplest way of doing this is to touch a conductive, grounded
object (e.g. bare metal cabinet component immediately beforehand).
PCBs must not be allowed to come into contact with highly insulating materials (e.g. plastic foil,
insulating table tops or clothing made of synthetic fibres).
PCBs may only be set down on electrically conducting surfaces.
SIEMENS AG 6RX1700-0AD76
SIMOREG DC Master Operating Instructions
Start-Up
7-1