Configure Basic Settings - Yamaha MMP1 Operation Manual

3-3-2. MMP1 Controller
Select an MMP1 on the "Select MMP1" dialog box. The
"Select MMP1" dialog box is displayed when launching
the MMP1 Controller.
NOTE
You can also display the "Select MMP1" dialog box from the
menu bar to change the desired MMP1 for operation at any time.
Disconnecting from the MMP1
1 Select the MMP1 connection.
2 Tap to select the MMP1 to operate.
3 Tap to connect.
NOTE
• You can switch between Wireless/Wired on iOS 9.3 or later
devices.
• You must enter the Passcode for the MMP1 when connecting
to an MMP1 with a Passcode set. Entering a passcode is not
necessary when connecting to the same MMP1 as that used
previously.

3-4. Configure basic settings

NOTE
Only the MMP1 Editor can be used to configure basic settings.
Basic settings must be configured on the MMP1 Editor before the
MMP1 Controller can be used.
1.
Select "
"New."
1
2.
Select whether or not you want to use the Setup
2
Wizard.
Next, follow the on-screen instructions.
When using the Setup Wizard, configure basic settings by
answering the questions as they appear on the screen.
3
Canceling the Setup Wizard before it is complete will
revert settings to what they were prior to launching the
Setup Wizard.
When the Setup Wizard is not used, the following values
will be applied automatically.
Sample Rate
Speaker Format
LFE Filter
LFE Trim
Bass Management
Monitor Source
Speaker Set
Cue Mix Input Channel
Cue Mix Output Channel
Talkback Mic Input Channel
(file icon)" on the menu bar, then select
48 kHz
Stereo
None
None
None
None
None
None
None
None
MMP1 Operation Manual
3. Setting Up
6